Vogue Soap Holder

Instructions Screw On If you are fixing a (Towel Rail-Towel Ring or Toilet Roll holder) Place the backing plate in the required position and carefully mark the holes to be drilled. If fixing a toothbrush holder or soap dish hold the actual plate item in the required position and carefully mark the drill holes. If fixing the product to tiles place masking tape in the required position and mark the position of the holes on the masking tape. Leave the masking tape in position while drilling the hole. Using a 6mm drill, carefully drill the required holes using the highest speed setting available. Insert the plugs provided into the drilled holes and insert the screws provided through the brackets into the plugs. Tighten to a loose fit and align the product or backing plate to ensure it is level before finally tightening to a secure fit. If you have fitted a backing plate (Towel Rail-Towel Ring or Toilet Roll holder) simply clip the fitting to the backing plate and your product is -ready to use. To Remove-Pull the item from the mounting bracket and undo me screws STICK-ON Ensure the wall surface is clean and free from grease or dust; allow new paint 4 weeks to cure before use. Ceramic tiles should be cleaned with an abrasive powder cleaner to remove any silicone deposits. Porus surfaces such as unpainted plasterboard, brick or cement should be sealed first. (Hairspray will work if there is no intention to paint) Carefully mark the required position as repositioning later will greatly reduce the adhesion. Peel of the backing paper. DO NOT TOUCH ADHESIVE Press firmly lo the required position and leave for 12 hour before use TO Remove-cut through the adhesive with a sharp knife and rub off the remaining adhesive with a cloth placed over the thumb. Item can be re mounted with Fixon Mounting Tape.